On Delay Timer and Off Delay Timer with TIA PORTAL

 Hello my readers I'm Seyit Baha Kılıçkap and today I'm going to show you how to use On Delay and Off Delay Timer with TIA PORTAL.

(figure shows the real looks like On-Delay Timer)

So first things first what is the On Delay Timer and Off Delay Timer ? As you can see the figures under here, It's delayer for the circuits let's look closer, For On-Delay Timer (a.k.a. TON) when Input comes at the timer there is a delay time for the output then output bool going to be 1 , for the Off-Delay timer (a.k.a. TOF) when Input comes It's going to give Output 1 and then if you stop the input It's still give Output 1 signal for a delay time 

That's the information of the 2 common Timers so lets go for the TIA Portal side, lets make a case about it, There will be a  seal network and if the signal comes to timer the timer delays the signal for 4seconds and 3MiliSeconds then start the motor and motor lamb.

So as you can see at the top figure , at network 1 there is a basic sealer circuit (which you can learn more about this link) and at Network 2 there is TON timer , so lets just look closer to it , IN means the signal's input, PT means Progress Time which you set your delay time in our case we use 4S3MS (4 seconds and 3 Miliseconds), ET means Elapsed Time, and the Q means signal output. 

When the "Timer Girişi" 1 timer is going delay the output signal for 4 seconds and 3 MiliSeconds then the output signal reaches the Motor and the Motor Lamb when you want to stop it you can use the Stop But which makes close circuit to open circuit.

 

Lets make a case for the OFF-Delay Timer , when the start button pushed then released the button the motor and the motor lamb going to use for 3 seconds

 So as you can see at the network 1 there is simple seal network with set and reset button (if you want to get more information about this you can click here) in our case we need to push button then at the release time we got the signal so we use the Negative Edge Triggering for start button, lets go for network 2 , at the starting we use network 1's output then we use TOF (means Off Delay Timer) for the delay , It delays 3 seconds(as we talk about the TON timers at upper) when the signal gones the delayer give logical 1 output for a 3 seconds to Motor and the Motor Lamb

That's all for TON and TOF you can contact me with this link if you have a question.